ALFAGTV6.COM

Hi Murry,

I am trying to put together my MS11 V3, I would appreciate some photo's if you have any as it will compliment the wireing diagrammes I have and hopefully make the installasion smoother.

Cheers
Paul Uk

Hi Domenic,

Sounds like you had fun, what do you think of the manual? is it any good to you?

Paul UK

Hi Domenic, have you received the engine manual I sent you? It should have got to you by now.

Cheers
Paul UK

Hi Domenic, if you send me your address I will send you a copy.

Email: paulbird666@live.co.uk

Cheers
Paul UK

Hi Domenic, I have a great book that I can photo copy for you, it is a complete strip down and rebuild manual for our beloved GTV6 2.5L & 3.0L including all torque settings. Would you like a copy?

Paul UK

I have looked at the diagramme and found where most of the wires go in relation to the l-jet ecu but I dont know what number the f-idle and spark-A go to.


Paul UK

Hi Marcus, the pdf downloaded ok, many thanks. I must be no good at this stuff,im just as confused as before, maybe I should just send it to you with some cash and get it done by someone who knows what they are doing!!!!

Im sure I'll get to grips with it.

Cheers
PaulUK

Hi Marcus, you dont have a list of what wire on the DB37 goes to which number on the ljet connector do you?

Cheers
Paul UK

Hi, yes I will check all the front suspension at the weekend. As I recall, the bushes did go in quite easily, I also think that it is the passenger side which is at fault as the drivers side has plenty of clearence all round equally.

I willlet you know!!

Paul UK.

Hi Zamani, yes I did change all bushes, I did think that this may have caused the problem, what is the solution?

Paul UK.

Hi guys, thanks for the replies. I have the caster rod ball joint and I have adjusted it fully, all this has done is pull the upper arm towards the RS coilover. I have 17 x 8 momo GT2 wheels and I have had these on my previous GTV6 with no problems. Is there any adjustment on the lower arm? As far a...

Hi all, I wonder if anyone can help. I have spent some time rebuilding my GTV6 from the ground up. All suspension components were removed, shot blasted and powder coated and re-assembled with new bushes and bearings including the RS set up. The car hasnt been on the road yet as it is awaiting a resp...

Hi marcus, that was a quick reply, thanks. I have already got a gutted l-jet box ready to go, I just need to do the soldering. I have a schematic from Steve Rosser but I am no electrical wizard, I like to work from photo's as well as drawings. I also have a DB37 pigtail. I would like to make the tra...

Hi Marcus, do you have any pics of your MS11 install? I have a MS11 v3 to install in my GTV6 3.0L but dont know where to start so any help would be greatfully accepted.

email: paulbird666@live.co.uk

Cheers
Paul UK

Hi Alfaboy, where in the UK are you?
I am in sunny Dorset.

Paul UK