Hi again people,
I've been fairly busy lately and am just getting around to the finishing touches on my ms build and have probably what is a stupid question but thought I would ask just incase. I'm building an ms3 board and want to get the msextra add on aswell to run individual coil packs.
My question is do I build the coil driver circuit the same as in the instructions for the ms2 on the v3 board I can't seem to find a definant answer and i don't want to be installing things I will have to unsolder later. From what I have read this will give the ignition output to pin 36 and this is not what I would be using, but will that circuit be used for the ms3x aswell?
Thanks in advance for any help
Related to the Bowling & Grippo Fuel Injection system.
1 post • Page 1 of 1