Fast question: How thick are the Reinz, Goetze and Spesso gaskets? I have new Corteco and Payen gaskets here and their thickensses are 1.75mm and 1.85mm uninstalled. I also have used Payen which is 1.75mm, which was too high for my engine.. Maybe it would be 1.7mm as installed, so maybe Corteco would be 1.6mm then?
Navalinea gasket is 1.6mm, but the optimal would be 1.4-1.5mm in this case.
Re: TS bottom end rebuild
Kimmo / alfatune.fi
-
Maurizio
- Verde
- Posts: 680
- Joined: Wed Dec 01, 2004 4:49 am
- Location: the Netherlands, 153.1km from the N'ring :-)
Re: TS bottom end rebuild
I have a used Reinz laying around and that is 1.6 [mm]
Banned.. ? 
Daily donky.. ==> BMW 325d 
E36M3 (3.0) Ringtool
==> definitely BANNED!
AR 75 TS Ringtool '90, AR Spider 2000 veloce '79
Daily donky.. ==> BMW 325d E36M3 (3.0) Ringtool
==> definitely BANNED! AR 75 TS Ringtool '90, AR Spider 2000 veloce '79
Re: TS bottom end rebuild
I found that reinz has 1.4mm gasket for Nord engine, so I ordered it. Let's see..
Kimmo / alfatune.fi
Re: TS bottom end rebuild
The gasket is already at 1.4mm before compressing. Probably it's around 1.3mm when on use. Looks good 
Kimmo / alfatune.fi