I can 3D print short pipe sections in case you need it them to fabricate exhaust/header/manifolds
I was thinking of selling them maybe at a price of $2/bend. So for a typical header maybe you would need bout 10-20 short bends to figure out what your real bends are going to be . I can pretty much print them in any diameter and bend angles.
So $20 + $5 shipping would get your 10 bends which should be enough for a header project. Re-sell it to someone if you want. I'm not here to make a fortune.
1 post • Page 1 of 1
- exhaust_bends_3d_print_small.jpg (19.91 KiB) Viewed 1332 times