Note the thickness whrere disk meets the diff flange and cv joint flange:
Sorry for the quality of the pics, but it's my always-handy cell which has meet the ground far too many times...
Anyway difference between the two is 3mm
So if you re tightening that bolts and that rotor is still loose... Well buy a proper thicker rotor or grind off some material from the CV flange
2 posts • Page 1 of 1
- Early type rotor
- DSC00768.JPG (47.18 KiB) Viewed 2525 times
- Late type rotor, as found on 75...
- DSC00767.JPG (34.93 KiB) Viewed 2529 times
Huh I seems this was not the discovery of America after all