A couple of friends are possibly parting out their racecar and I'm eying the AP calipers...
http://www.apracing.com
One problem though, they are "trailing edge" calipers.
Because the pistons aren't the same size I can't just put them on the other side, the pads would taper like crazy.
Looking at the calipers I suspect that I could just switch over the crossover pipe and bleed screws but since I don't have the calipers here I can't really see...
Anyone knows if I'm correct in my assumptions?
Barry, I'm looking in your direction...
Switching AP CP5200 Calipers around
Mats Strandberg
-Scuderia Rosso- Now burned to the ground...
-onemanracing.com-
-Strandberg.photography-
GTV 2000 -77 - Died in the fire.
155 V6 Sport -96 - Sold!
-Scuderia Rosso- Now burned to the ground...
-onemanracing.com-
-Strandberg.photography-
GTV 2000 -77 - Died in the fire.
155 V6 Sport -96 - Sold!