Page 2 of 2
Re: 280 Rear wheel horsepower on a low budget
Posted: Thu May 03, 2012 1:18 pm
by kevin
Greg what is the average rw hp figures for the 3.0 12v without a SC kit with a standard motor ( from the motronic 164) and an after market ecu with "free flow" exhaust .
Zero mods to any internals . Just trying to get into perspective . I do not need exact figure just an estimation .
Re: 280 Rear wheel horsepower on a low budget
Posted: Thu May 03, 2012 1:26 pm
by Greg Gordon
I haven't seen dyno results for a Motronic 3.0, but in a standard Verde with an ECU mod (Zat, Kirshtein, etc.) and a really good exhaust they are normally about 150rwhp. I suppose a 164S motor with the same treatment would be around 175rwhp.
Greg,
www.hiperformancestore.com
www.okinjectors.com
Re: 280 Rear wheel horsepower on a low budget
Posted: Thu Jun 07, 2012 7:49 am
by fedezyl
Hey Greg, since you are not building your SC kit's anymore I was thinking about doing it the cheap way and getting a SC out of Ebay. I was looking around and just could find M90's, no M62's, I know it's a bit big but it can work on a 3L.
You still sell the pulleys, tensioner and discharge port right?
Re: 280 Rear wheel horsepower on a low budget
Posted: Fri Jun 08, 2012 1:09 pm
by Greg Gordon
The M90 will work pretty well on a 3.0. I have pulleys, but no discharge ports for the M90. I never bolted up an M90 so I don't have anything specific for it.
Greg
Re: 280 Rear wheel horsepower on a low budget
Posted: Fri Jun 08, 2012 2:41 pm
by fedezyl
Greg Gordon wrote:The M90 will work pretty well on a 3.0. I have pulleys, but no discharge ports for the M90. I never bolted up an M90 so I don't have anything specific for it.
Greg
Great, i'll PM you for the details on price, thanks!