User avatar
Mark Walshaw
Gold
Gold
Posts: 131
Joined: Mon Apr 18, 2011 2:51 am
Location: Formerly Cape Town,now Gangsters paradise

Re: GTV 6 2.5 V6 running problems

Post by Mark Walshaw »

Think I found the problem, something is loose in the dizzy. i took the rotor off and the center piece the looks like a spider( don't know what you call it) is loose, I moved it back and forward a couple or times, Don't know it's exact location but when I drive the car power was almost back to normal.
Does anybody have an exploded view of the GTV6 distributor.
Attachments
Dizzy.jpg
Dizzy.jpg (41.82 KiB) Viewed 8339 times
User avatar
Mark Walshaw
Gold
Gold
Posts: 131
Joined: Mon Apr 18, 2011 2:51 am
Location: Formerly Cape Town,now Gangsters paradise

Re: GTV 6 2.5 V6 running problems

Post by Mark Walshaw »

i think i have found the problem, took the dizzy cap and rotor off, and moved the spider ( not sure what it is called) clockwise and anti clockwise a couple of times. Now the power is almost back to normal, but I don't know its exact position and if it's meant to be loose or not.

Does anybody have an exploded view of the GTV6 distributor?
Attachments
Dizzy.jpg
Dizzy.jpg (41.82 KiB) Viewed 8339 times
User avatar
fedezyl
Verde
Verde
Posts: 645
Joined: Wed Jun 01, 2005 2:45 pm
Location: Montevideo, Uruguay

Re: GTV 6 2.5 V6 running problems

Post by fedezyl »

The dizzy will rotate a few degrees with the engine shutdown as that is what it corresponds to the vacuum advance. You might be having trouble with the diaphragm in the vacuum advance, try disconnecting it and see if it makes any difference, if it does just change it.
User avatar
Mark Walshaw
Gold
Gold
Posts: 131
Joined: Mon Apr 18, 2011 2:51 am
Location: Formerly Cape Town,now Gangsters paradise

Re: GTV 6 2.5 V6 running problems

Post by Mark Walshaw »

Ok power is back, but still has a misfire, stutter or hesitation at constant throttle. I have checked compression which is ok, AFM spring is great fuel pressure is good. Trimming is spot on as we'll as vacuum advance. Only thing is plugs which are new, 1,3,4 and 6 are burning a little black while 2 and 5 are a dull brown. Can't think what else I should check, it has to be something small as it only comes about when cruzing and not under load.
Pic of plugs 1 on left through to 6 on right.
Attachments
image.jpg
image.jpg (29.44 KiB) Viewed 8305 times
MR2 Zig
Verde
Verde
Posts: 766
Joined: Tue Jun 13, 2006 9:47 pm
Location: Fresno, Ca.
Contact:

Re: GTV 6 2.5 V6 running problems

Post by MR2 Zig »

Lean misfire? I would think that would leave plugs white, but I'm not sure.

Leaking injectors is the other thing that comes to mind. Greg Gordon may be of help on that.

Is the exhaust smelling rich at idle? It may be as simple as a minor mixture adjustment.

I hope that helps,
MR1 Zig (I made rate!)
Machinery Repairman USNR
User avatar
Mats
Verde
Verde
Posts: 4059
Joined: Mon Nov 29, 2004 12:26 am
Location: Gothenburg, Sweden
Contact:

Re: GTV 6 2.5 V6 running problems

Post by Mats »

Air leak after the Throttle...

Spray starter gas around suspicious points at idle.
Mats Strandberg
-Scuderia Rosso- Now burned to the ground...
-onemanracing.com-
-Strandberg.photography-

GTV 2000 -77 - Died in the fire.
155 V6 Sport -96 - Sold!
MR2 Zig
Verde
Verde
Posts: 766
Joined: Tue Jun 13, 2006 9:47 pm
Location: Fresno, Ca.
Contact:

Re: GTV 6 2.5 V6 running problems

Post by MR2 Zig »

Speakin of air laeks.....Have you had the injectors out and replaced the seals? Are your intake boots (between the manifold and intake pipes) in good condition?
MR1 Zig (I made rate!)
Machinery Repairman USNR
User avatar
Mark Walshaw
Gold
Gold
Posts: 131
Joined: Mon Apr 18, 2011 2:51 am
Location: Formerly Cape Town,now Gangsters paradise

Re: GTV 6 2.5 V6 running problems

Post by Mark Walshaw »

Hi replaced intake tube rubbers with silicone pipe so all good there,sorry for ignorance Mats, but what is starter gas?( Only one i know is used for starting diesel engines) Talking about air leaks is it possible plenum has a hairline crack that i am not picking up? ( has anyone heard about a crack in the plenum?) :oops:
User avatar
Mats
Verde
Verde
Posts: 4059
Joined: Mon Nov 29, 2004 12:26 am
Location: Gothenburg, Sweden
Contact:

Re: GTV 6 2.5 V6 running problems

Post by Mats »

Ether in a spray can basically. NEVER use for diesels unless you like explosions, uncontrolled ones. In your face. 8)

There are a bazillion small vacuum tubes and idle-control stuff and crank-case breather and such originating in the plenum so lots more to check besides the obvious intake hoses.
Like the injector seals mentioned above.
Mats Strandberg
-Scuderia Rosso- Now burned to the ground...
-onemanracing.com-
-Strandberg.photography-

GTV 2000 -77 - Died in the fire.
155 V6 Sport -96 - Sold!
User avatar
Mark Walshaw
Gold
Gold
Posts: 131
Joined: Mon Apr 18, 2011 2:51 am
Location: Formerly Cape Town,now Gangsters paradise

Re: GTV 6 2.5 V6 running problems

Post by Mark Walshaw »

Hi Mats
Thanks for info, will go and purchase some will the leak be noticeable, as in bubbles or what do i look for, (sorry learning experience here). :? :oops:
User avatar
Mats
Verde
Verde
Posts: 4059
Joined: Mon Nov 29, 2004 12:26 am
Location: Gothenburg, Sweden
Contact:

Re: GTV 6 2.5 V6 running problems

Post by Mats »

Idle speed increase when the ether is sucked in through the leaks. :)
Mats Strandberg
-Scuderia Rosso- Now burned to the ground...
-onemanracing.com-
-Strandberg.photography-

GTV 2000 -77 - Died in the fire.
155 V6 Sport -96 - Sold!
User avatar
Mark Walshaw
Gold
Gold
Posts: 131
Joined: Mon Apr 18, 2011 2:51 am
Location: Formerly Cape Town,now Gangsters paradise

Re: GTV 6 2.5 V6 running problems

Post by Mark Walshaw »

:D Great will try it tonight and report back what happens. :?:
User avatar
Mark Walshaw
Gold
Gold
Posts: 131
Joined: Mon Apr 18, 2011 2:51 am
Location: Formerly Cape Town,now Gangsters paradise

Re: GTV 6 2.5 V6 running problems

Post by Mark Walshaw »

Quick update. Started checking from scratch according to Greg Gordon's write up and with lots of help from Kevin via email from the UK.
Found fuel pressure to be only at 15 psi a posed to the 35,6 it should be. Check fuel pump and it putting out approx. 100 psi so it has to be Fuel Pressure Regulator. So will replace that, with the help of some friends on the forum. :D
Then will drive again to see how far this go's to solving he problem.

Thanks guys.
User avatar
Mark Walshaw
Gold
Gold
Posts: 131
Joined: Mon Apr 18, 2011 2:51 am
Location: Formerly Cape Town,now Gangsters paradise

Re: GTV 6 2.5 V6 running problems

Post by Mark Walshaw »

Quick update, placed FPR thanks to Dawie, check inertia switch and stripped Plenum down and rebuild, so no air leeks.. Power is back, but hesitation is still there, but seems to be getting worse. Dawie reckons blocked injectors or sticking dizzy.
So the fault finding moves on...... :idea:
Ryan88a
Silver
Silver
Posts: 9
Joined: Thu Jun 28, 2012 12:18 pm
Location: JHB - South Africa

Re: GTV 6 2.5 V6 running problems

Post by Ryan88a »

Then it must be the injectors!
Post Reply