A/C Adjustment Pulley Bearing Needed.

Post Reply
brookstroutr
Gold
Gold
Posts: 166
Joined: Tue Nov 30, 2004 2:55 pm
Location: Keystone Hgts, Floureyeduh

A/C Adjustment Pulley Bearing Needed.

Post by brookstroutr » Thu Sep 27, 2007 1:27 pm

The A/C belt adjustment pulley bearing is going. Is there a generic replacement for this? Any suggestions, TIA.
Regards,

N. G. Brooks Robinson
'84 GTV6
'84 M635CSi
jensen73
Silver
Silver
Posts: 2
Joined: Tue May 30, 2006 5:56 am

Post by jensen73 » Fri Nov 16, 2007 10:10 am

The bearing in the a/c pully is designed not to be replaced....However.. if you have a hydraulic press available, the old bearing can be pressed out. The pully has a lip machined over the bearing to hold it in place. I was able to do what you are asking useing a press. Once the bearing is out, a bearing shop can match a replacement. I used lock-tight and staked the rim of the pully to retain the bearing. So far, so good.
brookstroutr
Gold
Gold
Posts: 166
Joined: Tue Nov 30, 2004 2:55 pm
Location: Keystone Hgts, Floureyeduh

Post by brookstroutr » Mon Dec 03, 2007 7:11 am

Thanks. I have a press and can R & R the bearings. Do you happen to know what bearing you used?
Regards,

N. G. Brooks Robinson
'84 GTV6
'84 M635CSi
Post Reply