Search found 46 matches
- Mon Jun 11, 2007 4:46 pm
- Forum: MegaSquirt Fuel Injection
- Topic: MS-II build underway...questions
- Replies: 66
- Views: 74326
Doesn't the stock TPS allow for the flood clear with MS? I'm pretty sure it does with the Bosch setup. I thought it was a three way, idle, on, and damn the torpedoes mode. Anyway, I guess it wouldn't be that hard to hook up the Volvo one. I remember Kevin Oliver saying something about remembering th...
- Mon Jun 11, 2007 7:23 am
- Forum: MegaSquirt Fuel Injection
- Topic: MS-II build underway...questions
- Replies: 66
- Views: 74326
Thanks, would have been nice if they would have said that! Now time to clean the board of flux and then make the DB37 -> Bosch connector wiring. I plan on trying to get this working first with the basically stock system: * Keep AFM for now, I'm assuming I can just use the built in IAT sensor for now...
- Sun Jun 10, 2007 6:33 pm
- Forum: MegaSquirt Fuel Injection
- Topic: MS-II build underway...questions
- Replies: 66
- Views: 74326
- Sat Jun 09, 2007 4:09 pm
- Forum: MegaSquirt Fuel Injection
- Topic: MS-II build underway...questions
- Replies: 66
- Views: 74326
- Sat Jun 09, 2007 7:24 am
- Forum: MegaSquirt Fuel Injection
- Topic: MS-II build underway...questions
- Replies: 66
- Views: 74326
- Sat Jun 09, 2007 6:29 am
- Forum: MegaSquirt Fuel Injection
- Topic: MS-II build underway...questions
- Replies: 66
- Views: 74326
- Sat Jun 09, 2007 5:33 am
- Forum: MegaSquirt Fuel Injection
- Topic: MS-II build underway...questions
- Replies: 66
- Views: 74326
- Sat Jun 09, 2007 4:37 am
- Forum: MegaSquirt Fuel Injection
- Topic: MS-II build underway...questions
- Replies: 66
- Views: 74326
Thanks, will do. So by going this route does it make it much harder to swap back to the L-Jet in the event that something goes wrong with my MS? I'm planning on going to this years convention with the MS in the car but don't want to get stranded in the middle of nowhere because one of my solder join...
- Fri Jun 08, 2007 6:02 pm
- Forum: MegaSquirt Fuel Injection
- Topic: MS-II build underway...questions
- Replies: 66
- Views: 74326
- Thu Jun 07, 2007 3:39 am
- Forum: MegaSquirt Fuel Injection
- Topic: MS-II build underway...questions
- Replies: 66
- Views: 74326
- Wed Jun 06, 2007 5:03 pm
- Forum: MegaSquirt Fuel Injection
- Topic: MS-II build underway...questions
- Replies: 66
- Views: 74326
MS-II build underway...questions
Well, I've finally gotten around to starting the MS build. I'm taking it slow and I've gotten up to the part where I tested the serial port connection. So far I've got two things that are annoying and they both are related to the DB37 connector. The first is that the screws that hold on the front pl...
- Tue May 08, 2007 4:40 pm
- Forum: MegaSquirt Fuel Injection
- Topic: Close to ordering my MS kit need some advice
- Replies: 10
- Views: 14847
- Mon Apr 09, 2007 10:20 am
- Forum: MegaSquirt Fuel Injection
- Topic: Close to ordering my MS kit need some advice
- Replies: 10
- Views: 14847
Close to ordering my MS kit need some advice
Been reading as much as I can and am getting close to ordering my MS kit to put in my stock Verde 3.0L from DIYAutoTune and just wanted to get a couple opinions. I'm planning on ordering: MS-II v3.0 kit Stimulator v2.2 kit LC-1 wideband controller with sensor Rather than pulling an air temp sensor o...
- Wed Dec 06, 2006 9:21 am
- Forum: MegaSquirt Fuel Injection
- Topic: MS or MS-2?
- Replies: 11
- Views: 13019
Yup, still running the 164 engine. Has been running pretty well but this one burns oil too, although a lot less than the previous one! It has started to smoke somewhat now but only when I idle for awhile or when I first start up after it has been sitting for awhile (outside temp doesn't matter), as ...
- Wed Dec 06, 2006 5:31 am
- Forum: MegaSquirt Fuel Injection
- Topic: MS or MS-2?
- Replies: 11
- Views: 13019