Search found 8 matches

by manuel164
Thu Jun 21, 2012 1:13 am
Forum: Suspension, Steering, Wheels, Tires
Topic: Few questions for spring rate (without torsion bars)
Replies: 10
Views: 4907

Re: Few questions for spring rate (without torsion bars)

Hi!

Can someone insert the full spec of the setting?

Thank you
Manuel
by manuel164
Sun Nov 06, 2011 12:53 pm
Forum: Gearbox, Clutch and Driveshaft
Topic: Alignment Engine-Gearbox
Replies: 28
Views: 12990

Re: Alignment Engine-Gearbox

About the middle pinion i will take a look!

And about the pics here about the gear shifting, please take a look the 3:26, interesting setting!
How does he make the "rotation"?

http://www.youtube.com/watch?v=-Qnls-e4s3A
by manuel164
Fri Nov 04, 2011 1:08 am
Forum: Gearbox, Clutch and Driveshaft
Topic: Alignment Engine-Gearbox
Replies: 28
Views: 12990

Re: Alignment Engine-Gearbox

Hello! Thanks for your answers, these helps me a lot. About the location of the gear linkage, could you send me some more pics about it? Its also an issue for me to change it, because the gear handling is not the best i think, it could need some improvement. About the engine mounts: The old ones are...
by manuel164
Mon Oct 31, 2011 10:56 am
Forum: Gearbox, Clutch and Driveshaft
Topic: Alignment Engine-Gearbox
Replies: 28
Views: 12990

Alignment Engine-Gearbox

Hello, I have some vibrations in my GTV6` propshaft. :cry: The story: After new three engine rubbers, i wondered about the alignment of the engine, the crank axis was showing a little bit to the right rear wheel. After setting with a laser the engine straight to the gearbox entry with an extra fitte...
by manuel164
Tue Oct 04, 2011 11:04 pm
Forum: Fuel, Electrical & ignition (stock Bosch)
Topic: Smaller starter for V6 - to close to CSC header
Replies: 2
Views: 2057

Re: Smaller starter for V6 - to close to CSC header

hm, the gap is very small, here is a picture of it.
i will try with heat insulation.

thank you
by manuel164
Mon Oct 03, 2011 11:23 am
Forum: Fuel, Electrical & ignition (stock Bosch)
Topic: Smaller starter for V6 - to close to CSC header
Replies: 2
Views: 2057

Smaller starter for V6 - to close to CSC header

Hello!

I have a problem with my CSC headers and starter.
On the right side, the header is very close to the starter, approx. 5mm.
Is there any chance to get a smaller starter from an other car?

Thank you
Manuel
by manuel164
Tue Dec 29, 2009 7:45 am
Forum: Exhaust System
Topic: X-Pipe on a Transaxle V6
Replies: 1
Views: 2674

X-Pipe on a Transaxle V6

Hello!

What do you think of an X-Pipe for a V6?
Better torque or horsepower possible?

cu
Manuel
by manuel164
Wed Jul 30, 2008 1:45 am
Forum: Body (exterior)
Topic: Maratona kit
Replies: 5
Views: 3367

Could you upload a picture of the kit or whole car?

Thank you