ALFAGTV6.COM

Tis a minta! And one of only 686 world wide!!

Up to step 22 on the build. The option for an IAC stepper motor. We dont have these, right? Do I disregard and carry on? Is the IAC a cold idle instrument?

Cheerz Tim.

Yep cheerz guys. I reckon I might do the good job on them. No point in spending the coin on the paint and skimping on the plastics.

Coool. Like drifting?

So I've got all this faded grey plastic bits that will need to go back to thier home on the GTV. What is every one using to tidy up these parts?

I thought of spraying them with black paint. I've tried a back to black solution but it was crap. I really need the bits to be BLACK again.

Really need to drop the rear a bit to level her out after the front was dropped. Can any one suggest a rear coil rate that I should be looking at? RSR's coils range from 40-56-70 Kgs. We have quite poor roads down here so I dont need any thing too rigid and dont want it soft either. Maybe 56 kgs is ...

Just did it.

Orrrr. That main page.. Ta for the link. Murray planning on getting the MS2 v3 as I would be looking to learn about the fuel side the after that get into the ignition department. Still at the beginning stages of the MS introduction manual at the site. Once I've studied up as much info there I'll ode...

Can some one post a link to Steve R's Megasquirt install and build guide. I've been searching high and low and am having trouble locating it.

Cheerz Tim.

Seems the rest of the world is getting concerned about the availabilityof them.

Try here. http://www.international-auto.com/index ... id=1173957

Mats what/why did the electrode get eaten away? I've run Iridiums through some very tough enviroments and harsh conditions and they have stood up very well for years. Which brand?

I've allways used Iridium sparkers in all my engines (bikes and cars). They just make things crisp and clean. Worth every penny IMHO. I use NGK brand.

Very cool! Where would you expect the power/torque peak to be with that length of primary? Any other mods?

Anyone have a blown ECU? I just need the case to fit M/S into.

Cheerz Tim.