ALFAGTV6.COM

I was able to remove it. But exactly how I can no longer remember. I have a feeling you need to pop out the toggle switch first. (it should come out if you pry it upward) then unscrew the ring.

Greg

Hey pat,
luck for you i made a note of the size before i installed.
I purchased it from I.A.P.

I.D. 5.84mm
O.D 12.70mm
Thickness 3.42mm

Greg

Hey guys, Thanks for all the help on this matter. I wish i could say that i finally got my steering wheel off, but no luck yet. Here'a a picutre of the puller i used. This should of worked. it builds up good pressure. but instead of pulling the steering wheel off it bends it where the metal tabs res...

Mats,

I did try a puller but i had a slighty different set up. Your steering wheel hub look different. is it from a momo?

Greg

OK. This is getting to be a bit to much for me. I cant get this steering wheel off. I pulled the whole colulm out and had it on my vice and i was banging on the shaft with a small sledge hammer and a hard piece of wood. I also tried a 3/8" socket extension. I tried to get it off with a puller.....

Thanks for the tips guys. I'll let you know if i'm able to get my steering wheel off, w/ the whole thing removed. I've tried using different pullers on the steering wheel with no luck. Infact i've bent the crap out of the steering wheel and still wouldn't come out. Now i need to find a replacement w...

Kevin,

How did you solder them if they're the crimp on type?
Did you remove the plastic sleeve, and solder them without crimping?

Greg

kevin,

It seems mine is the same too. the wires go staight to the fuse box. Silly that they would make it without a connector. Did you cut and then put in some spade connectors?

Does anyone have a spare steering wheel they're willing to part with?
mine is in rought shape.

Greg

Hey guys, I'm in the middle of trying to get my steering wheel off. I'm trying to romove the wheel and the shaft combined and then remove the shaft later(Just like you guys did) I'm looking at how to disconnect the wirring. I've noticed that all the wires have connectors except fort he wires going i...

The reason why i originally asked was because there was one for sale on ebay. But that was a long time ago. It would be good to know for a spare.

Greg

Busso,
thanks for the response.
I haven't fixed the problem as of yet. sometimes the rev counter gets stuck. I wonder if the needle from another car would work? I'll give your method a shot.

Greg

hey guys, This may sound like a dumb question but i can't for the life of me figure it out. how do you remove the power mirror swtich. There's a round metal nut that sit's bellow the plastic switch that isolates the side you want to control. I can not completely loosen the nut because the plastic is...

Sounds like a plan.

thanks for the tips. i'll keep you guys posted. hopefully it goes well.


Greg A

This will be the first time i'll open up an alfa tranny. so basically i should check the clutch pressure plate setup and make sure it's not rusty. checkt he flywheel too. When you say suck it and see....does that mean install it and hope for the best? i know that the driveshaft is balanced on these ...

hey guys. so i have a rebuilt transmission from a parts car that hasn't been started for 6 years and the last time it was on the road was in 96. The previous owner tells me the syncros were replaced and it has a new clutch. before he stopped driving it. Should i just pop in the new tranny? or should...