Hey guys,
Ok, sorry I’ve been absent. It’s been a crazy few years with moves up and down between syd and melbourne, juggling an ill dad and getting back into flying, but I finally got the car back to syd the other day and can get stuck in to finalising a few things.
Here is the list.
2x nice to have but not required to have:
* a friend fabricated a few plate steel copies of the factory pedal box that bolts into the factory spot, uses a factory Clutch MC (preferably early type with reservoir on the MC), then accepts 2 x Tilton MCs for front and rear circuits. There is a slightly different pin required to hinge the pedals, but it uses factory clutch actuation and a fabricated 8mm steel brake pedal actuating the MCs via a balance bar. Bloody brilliant. I’m starting to build this and may end up fitting it before the csr goes for registration.
My current arrangement is untested, but we tapped the AHM ITB runners for 1/8” NPT vacuum lines that run into a vacuum tree/distribution block mounted on the firewall behind the valley. One outlet goes to the booster via a check valve and the other goes to a T piece for the Fuel Psi Reg and the MAP sensor.
I’d prefer to ditch the booster and RHD crossover bar for this pedal box. sooooooo much simpler.
* I have a spare steering column and I’m working on a Yaris power steering conversion that would ens let me to use the factory column housing and shroud, thus the stock ignition barrel etc. I think it can be done, but I won’t have it ready straight away.
* Fit Abarth 500 alternator as per guidance from Kevin (thanks again, legend!)
* clean up radiator hose from T/stat toT piece.. my T stat is mounted a bit further towards the rad than others have seemed to achieve, so I have to go hose digging to find something
* Fit my modified tail shaft - the front section is chromoly and will use a donut with a cage.
The centre section has a GM Commodore CV fitted, the rear has a V6 donut.
I had the car on a hoist briefly the other day and attempted to lever the rear engine mounts off and fit my donut and Tailshaft but ran out of time, so it will have to be done somewhere up here in Sydney when I get a chance.
* All fluids in and brakes/clutch bled with handbrake working.
* wheel alignment, although, I think I’m going to have to down from 45 profile tyres to 40 profile in order to clear my guards.
This is even after having the guards cut and the GP flares sectioned, lengthened and then trimmed underneath, to clear the wheels.
* car is to be re-wired by a professional auto elec in western Sydney.
It’s a bit involved- Hella H4 and H1 conversion at front with LED globes, LED globes rear, the factory heater box has been removed and I’ve mounted a 12v electric heater and blower fan against the firewall feeding the footwells and Demister vents. This requires its own 40A fuse. No more coolant in the cabin…
Also have the Yaris power steering motor and ECU, as well as the Speedhut gauges and the Motec (flying lead loom needs terminating).
Using a PDM is a possibility.
* re trim interior, although I have seat covers to make a template off, so won’t be too involved. Currently talking to a trimmer.
* Dyno tune
* shakedown
* fix whatever I break
****