Page 1 of 1

anyone have specs for custom A arms

Posted: Fri Sep 30, 2005 12:34 am
by zambon
Does anyone have specifications/measurements for custom A arms? I would like to commission the production of a set for one of my verdes but I am not the person to make the design :oops:
I would like to go to coilovers on the car, so torsion bar compatability is not necessary. That said, it would be a plus, I am not one to burn bridges...

Thanks
James

Posted: Wed Oct 05, 2005 12:38 pm
by TurbMarc

Posted: Thu Oct 06, 2005 8:24 pm
by 81GTV6
Why do you want new A-arms? Does the current set up not allow coilovers?

If whatever club/class i choose to race my car in allows it i will probably end up making steel tube A-arms to match the 50mm offset at the rears. Most likely that wont be of much help but if the prosses turns out easier than expected i wouldnt mind taking orders.

Posted: Thu Oct 06, 2005 9:02 pm
by ar4me
Upper control arm has tight clearance for coil-over. Lower A-arm is heavy.

Jes