Post Reply
User avatar
xrad
Verde
Verde
Posts: 516
Joined: Mon Feb 08, 2010 9:45 am
Location: Canton, Ohio

supersprint (made in Italy)

Post by xrad »

anyone use this..?

Do they fit well?

Cost: 1531$
Attachments
30982.jpg
30982.jpg (57.18 KiB) Viewed 7819 times
kanga
Silver
Silver
Posts: 33
Joined: Fri Jun 05, 2009 2:07 am
Location: Australia

Re: supersprint (made in Italy)

Post by kanga »

I put a set on my car, they fit perfectly and don't hang down as much as the stock ones. Best of all is the performance increase.The hardest part was connecting them to the downpipes which I think you will need as well.
User avatar
xrad
Verde
Verde
Posts: 516
Joined: Mon Feb 08, 2010 9:45 am
Location: Canton, Ohio

Re: supersprint (made in Italy)

Post by xrad »

any interference with the starter heat shield?

or motor mounts?

These are made for 2.5L. I have 3.0.....performance loss?
kanga
Silver
Silver
Posts: 33
Joined: Fri Jun 05, 2009 2:07 am
Location: Australia

Re: supersprint (made in Italy)

Post by kanga »

No heat shield now as it would need modification, but the headers are further away from the solenoid than the stock headers.
3ltr? You would need to compare their stock headers with the 2.5 stock headers I think the 3ltr and 2.5 may be the same, but not 100% sure.,
No prob at all with motor mounts
User avatar
xrad
Verde
Verde
Posts: 516
Joined: Mon Feb 08, 2010 9:45 am
Location: Canton, Ohio

Re: supersprint (made in Italy)

Post by xrad »

thnaks for info!
MR2 Zig
Verde
Verde
Posts: 766
Joined: Tue Jun 13, 2006 9:47 pm
Location: Fresno, Ca.
Contact:

Re: supersprint (made in Italy)

Post by MR2 Zig »

so far as I know there is no external difference from the 2.5 to the 3.0 until you get to the 24v. The thermostat housing is different on the Milano / 164 and somewhere (164 ithink) the starter got smaller.

I don't think you will have any problems.
MR1 Zig (I made rate!)
Machinery Repairman USNR
User avatar
TS_turbo
Gold
Gold
Posts: 185
Joined: Fri Dec 24, 2004 10:06 am
Location: Bulgaria
Contact:

Re: supersprint (made in Italy)

Post by TS_turbo »

1530 $ thats insane :shock: i made custom set for fwd gtv 3.2 and they cost triple times less :lol:
Attachments
DSC00082.JPG
DSC00082.JPG (113.58 KiB) Viewed 7640 times
DSC00081.JPG
DSC00081.JPG (106.23 KiB) Viewed 7641 times
User avatar
xrad
Verde
Verde
Posts: 516
Joined: Mon Feb 08, 2010 9:45 am
Location: Canton, Ohio

Re: supersprint (made in Italy)

Post by xrad »

Those are very nice. I do have a welder and stainless cored wire for it. I just don;t have a way to make the plate mounts.

I will probably just stick with stock headers for now....and make sure the down pipes and rear sections are as free flowing as possible.
Post Reply