Switching AP CP5200 Calipers around
Posted: Tue Feb 15, 2005 11:47 am
A couple of friends are possibly parting out their racecar and I'm eying the AP calipers...

http://www.apracing.com
One problem though, they are "trailing edge" calipers.
Because the pistons aren't the same size I can't just put them on the other side, the pads would taper like crazy.
Looking at the calipers I suspect that I could just switch over the crossover pipe and bleed screws but since I don't have the calipers here I can't really see...

Anyone knows if I'm correct in my assumptions?
Barry, I'm looking in your direction...



http://www.apracing.com
One problem though, they are "trailing edge" calipers.

Because the pistons aren't the same size I can't just put them on the other side, the pads would taper like crazy.
Looking at the calipers I suspect that I could just switch over the crossover pipe and bleed screws but since I don't have the calipers here I can't really see...

Anyone knows if I'm correct in my assumptions?
Barry, I'm looking in your direction...

