Big bore headers
Anyone interested in headers for the 3.0 12V. They will have pretty long primaries (around the same length as CSC), made from stainless steel, and have around 42mm diameters for the primaries. I think it should be perfect for a mildly modified 3.0 12Vs. Price should be around Euro 600 (just an estimate) excluding shipping (from europe, God knows how much that is going to cost). But need a few interested parties before I can proceed.
Hey Zamani, I don't wanna be telling you how to suck eggs and I have no idea what the intention of these pipes are for so my comment is a shot in the dark but for a workhorse 3 litre I wouldn't be going more than 38mm ID if you want good bottom end torque which is where most of the work is done in the real world.
Transaxle Alfas Haul More Arse
-
- Verde
- Posts: 1552
- Joined: Mon Nov 29, 2004 7:06 pm
I think that would depend on how much power the car was putting out down low. I suspect the bigger tubes would help low and mid range power on a car with big power numbers down at low and mid range RPM. If you are talking about a standard 3.0 with S pistons and Cams it might not help, but a lot of people have much higher hp setups.