Page 2 of 2
Re: V6 12v Individual Throttle Body
Posted: Thu Mar 28, 2024 2:57 pm
by Duk
How's your 3D printing game, Z-man?
Design and print a decent plenum chamber in nylon. Just make sure there aren't any large flat surfaces.
It might look a bit like a dogs breakfast, but you don't look at the plenum when you're driving the car.
Re: V6 12v Individual Throttle Body
Posted: Thu Jan 02, 2025 9:16 am
by Giuliettaevo2
That OKTech plenum is pure art..
Re: V6 12v Individual Throttle Body
Posted: Sun Jan 05, 2025 9:51 am
by Zamani
I think any of his setups, either the really nice 2 piece RWD plenum or ITB is no less than $3K. Makes the AHM/Jenvey setup look like a bargain.
Re: V6 12v Individual Throttle Body
Posted: Sat Jan 11, 2025 3:40 pm
by KevinR
The Jenvey’s are really designed for the front wheel drive Alfas to fit under the bonnet hence they are sooo short. Ideally on the 24v when placed in the transaxle should have a longer runners with throttle bodies each side above the cam covers .
This is a current project leading on from the throttle body set up which we have just done on the 3.0 Carb heads . The new throttle body set up I will a mere spectator this time
