Need help on the Alfetta GTV6 propshaft

Post Reply
User avatar
Alfaaa1
Gold
Gold
Posts: 87
Joined: Tue Feb 02, 2016 10:36 am
Location: Melbourne , Australia

Need help on the Alfetta GTV6 propshaft

Post by Alfaaa1 »

Hello to all,
I am coming close to finishing my project.
I have a 1984 Alfetta GTV 4 cylinder car which I am converting to a 3.2 v6 busso.
Over here in Qz its very hard to find a complete GTV6 prop/tail shaft. :cry:

Does any one have one they would like to sell I would prefer to buy in Australia if possible.

User avatar
Alfaaa1
Gold
Gold
Posts: 87
Joined: Tue Feb 02, 2016 10:36 am
Location: Melbourne , Australia

Re: Need help on the Alfetta GTV6 propshaft

Post by Alfaaa1 »

Has any one tried using an Alfa 75 v6 prop shaft , front shaft is the same length bolt straight on the flywheel and the rear shaft shortened.

User avatar
killaz
Platinum
Platinum
Posts: 217
Joined: Mon Nov 19, 2007 2:44 am
Location: Belgrade, Serbia

Re: Need help on the Alfetta GTV6 propshaft

Post by killaz »

Friend of mine combined front shaft from 75 v6 and rear from original gtv alfetta 2.0 carbs. It was running ok as I remember.

I'm not shure if some additional mods were required... :(

User avatar
Alfaaa1
Gold
Gold
Posts: 87
Joined: Tue Feb 02, 2016 10:36 am
Location: Melbourne , Australia

Re: Need help on the Alfetta GTV6 propshaft

Post by Alfaaa1 »

Thank you killaz , I do have 2 x 4 cylinder prop shafts . I will try it soon, will let you know. :)

Post Reply