ALFAGTV6.COM

brookstroutr,

http://www.alfabb.com/bb/forums/showthr ... er+upgrade

The conversions I have seen or read about cut the lower part of the shifter off and weld in a Milano/86 GTV6 lower end. Then replace the shifter rod with the Milano/86 GTV6 rod and iso mech. And then for the lump hammer business....

I have edited my earlier post - I had wrongly remembered that the fork was on the shifter rod, not the shifter itself. Apologies.

Mats,

I'm taking your advice!!! I've now had two parts break on the iso set up so I'm swapping the input shafts to go back to the original simple shifter and rod. I didn't notice any shifting advantage and Andy at Performatek said the iso parts are getting scarce. IMHO, the iso set up is a bunch of crap. One of those good ideas, but....didn't work as well as thought.

Yeah..I hate to admit it but I took Mats advice too. I left in the standard arm...still hard to find 5th sometimes....

x-rad,

Try un der the seat!!!!

Just a joke! Showing my age. There was an old saying; "4 (spd) on the floor; 5th under the seat"... 5th of whiskey that is before we; the US; went metric on licker.

x-rad,

I take it from your reply, you found the 5th under the seat..... HaHaHa!!

Three on the tree, four on the floor and fifth under the seat?

I found 5th AND sixth (pack)

Hey, I had a 3 on the tree back in the day.

Anyway, I changed the shifter input rod back to the non-iso and everything/s fine. It shifts pretty dam good and I cannot tell much if any difference between the 2. Glad to get rid of the 1-2 rotten spread ratio.

Cheers............... sixth pack.. Now that's funny!!!!!!!!!!!

brookstroutr wrote:... 5th of whiskey that is before we; the US; went metric on licker.

Licker...? I didn't even kisser...

liquor n poker

in the rear






of the restaurant