Replacing throwout bearing, direction of belleview washer?
Posted: Sun Apr 06, 2008 2:08 pm
Hello everyone, I've resurfaced my clutch disk, and the two clutch surfaces. Now I'm installing a new throughout bearing. Single clutch for a milano, not double clutch like on a GTV6.
Two questions, the belleview washer is concave - which side goes down? I'm guessing the curvature of the belleview is opposite of the clutch fingers? This is so it can act like a spring?
Second question, book doesn't show two washers that I have. I'm thinking these two thin washers go on first, then the belleview, then the thick washer with the groove and finally the snap ring?
...maybe I took pictures....
Thanks,
Bill
Two questions, the belleview washer is concave - which side goes down? I'm guessing the curvature of the belleview is opposite of the clutch fingers? This is so it can act like a spring?
Second question, book doesn't show two washers that I have. I'm thinking these two thin washers go on first, then the belleview, then the thick washer with the groove and finally the snap ring?
...maybe I took pictures....
Thanks,
Bill