![Sad :(](./images/smilies/icon_sad.gif)
On the 24v front, I did some detail work on the valves and valve seats as I thought there was room for a little improvement. Therefore I will measure flow again this week and report. At this stage, I am convinced one should do their own seatwork for best results. Regrettably, different machine shops do them in different ways and if you know your stuff, you dislike most of their work! Buying my own quality cutter set (Neway) is expensive and not an option now -should have bought them 4-5 years ago. As a point of interest here, I have seen the best seats on std Alfa 33 16v heads; true radius seats! Anyway, stay tuned for more news from the bankrupt dump, later!
![Rolling Eyes :roll:](./images/smilies/icon_rolleyes.gif)
Jim K.